Lipfert Posted August 29, 2020 Report Share Posted August 29, 2020 Kameraden, I've been wanting to have proper functioning MFD's for Falcon BMS and DCS for awhile now, I had spec'd out the components and was looking to 3D print the parts and build from scratch. Recently found the Cube Sim folks and turns out the product was cheaper than the parts I was purchasing. Here's a little bit of the work I'm doing to get these going, I'm using the MonsterTech MFD mounts. I will have to do some milling to open up the vent fan and mounting cutouts on the back. It is possible that I could mount a 3rd one for the F/A-18 setup, since I have the grip as well now. Unpacking after arrival: Initial setup: Protective cover still in place: Socks: Both bad boys: Test install with keyboard shelf (super handy): More to come.... S! Snaggle, Britchot, Firefly and 2 others 5 Quote Link to comment Share on other sites More sharing options...
Klaiber Posted August 29, 2020 Report Share Posted August 29, 2020 The MFDs look great! Definitely let us know what you think of them. Lipfert 1 Quote Link to comment Share on other sites More sharing options...
Klaiber Posted August 29, 2020 Report Share Posted August 29, 2020 Also, nice looking socks. Snaggle 1 Quote Link to comment Share on other sites More sharing options...
Snaggle Posted August 29, 2020 Report Share Posted August 29, 2020 Tough to see in VR, until they allow us to see through the headset easily... Lipfert, Firefly and Klaiber 3 Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.